Suzuki Jimny Service Manual page 101

1B-40 AIR CONDITIONING (OPTIONAL)
4) Remove compressor drive belt (1) as follows.
For vehicle with P/S
Loosen tension pulley bolts (2).
For vehicle without P/S
Loosen tension pulley tightening nut (3) and adjusting bolt
(4).
[A] : Vehicle with P/S
[B] : Vehicle without P/S
5) Disconnect thermal switch connector.
6) Disconnect suction and discharge hoses from compressor.
NOTE:
Cap open fittings immediately to keep moisture out of
system.
7) Remove compressor (1) from its bracket (2).
NOTE:
If compressor is replaced, drain oil from removed com-
pressor. And then, measure its amount.
INSTALLATION
Reverse removal procedure for installation, and then noting the
following instructions.
• Replenish specified amount of compressor oil to compressor
suction side by referring to "Replenishing Compressor Oil" in
this section.
• Evacuate and charge system by referring to "Recovery" in
this section.
• Adjust drive belt tension by referring to "Compressor Drive
Belt" in this section.