Suzuki Jimny Service Manual page 615

6E-10 ENGINE AND EMISSION CONTROL SYSTEM
1. CKP sensor
2. CMP sensor
3. VSS
4. MAP sensor
5. Knock sensor
6. TP sensor
7. ECT sensor
8. IAT sensor
9. Heated oxygen sensor-1 (if equipped)
10. Heated oxygen sensor-2 (if equipped)
11. A/C evaporator temp. sensor (if equipped)
12. Speedometer
13. Fuel level sensor
14. TCM (A/T)
15. Transmission range switch (A/T)
16. Shift lock solenoid (A/T, if equipped)
17. Backup lamp
18. Heater fan motor
19. Heater fan switch
20. Power steering pressure switch
(if equipped)
21. A/C switch
22. A/C refrigerant pressure switch
(if equipped)
23. Immobilizer control module (if equipped)
24. Data link connector
25. Injector No.1
26. Injector No.2
27. Injector No.3
28. Injector No.4
29. IAC valve
30. EVAP canister purge valve
31. Fuel pump relay
32. Fuel pump
33. A/C condenser fan relay (if equipped)
34. A/C condenser fan motor (if equipped)
35. EGR valve (if equipped)
36. Malfunction indicator lamp
37. Immobilizer indicator lamp (if equipped)
38. Monitor connector (vehicle without immo-
bilizer indicator lamp)
39. Ignition coil assembly (for No.1 and No.4 spark plugs)
40. Ignition coil assembly (for No.2 and No.3 spark plugs)
41. Stop lamp switch
42. Stop lamp
43. Lighting switch
44. Position lamp
45. Rear defogger switch (if equipped)
46. Rear defogger (if equipped)
47. A/C compressor clutch (if equipped)
48. Ignition switch
49. Main relay
50. CO adjusting register (if equipped)
51. Starting motor
52. 4WD controller (4WD)
53. ABS control module (if equipped)
54. Engine ground
55. Body ground