Rear Axle Shaft Inner Oil Seal - Suzuki Jimny Service Manual

16) Upon completion of all jobs, depress brake pedal with about
30 kg (66 lbs) load over ten times so as to obtain proper
drum-to shoe clearance.
Adjust parking brake cable. (For adjustment, refer to "Parking
Brake Check and Adjustment" in Section 5.)
17) Tighten parking brake lever cover screws.
18) Check to ensure that brake drum is free from dragging and
proper braking is obtained. Then remove vehicle from hoist
and perform brake test (foot brake and parking brake).
19) Check each installed part for oil leakage.

Rear Axle Shaft Inner Oil Seal

REMOVAL
1) Remove rear axle shaft. For details, refer to "Rear Axle Shaft
and Wheel Bearing" in this section.
2) Remove rear axle shaft inner oil seal by using special tools.
Special tool
(A) : 09942-15510
(B) : 09944-96010 (remover)
(C) : 09921-26010 (collar)
INSTALLATION
1) Using special tools drive in oil seal (1) until it contacts oil seal
protector (2) in axle housing.
NOTE:
• Make sure that oil seal (1) is free from inclination as it
is installed.
• Refer to figure so that oil seal (1) is installed in proper
direction.
Special tool
(A) : 09913-75520
"A" : Grease 99000-25010
2) For procedure hereafter, refer to "Rear Axle Shaft and Wheel
Bearing" in this section.
3. Differential side
REAR SUSPENSION 3E-17