Suzuki Jimny Service Manual page 285

5-24 BRAKES
ASSEMBLY
CAUTION:
• Wash each part cleanly before installation in the same
fluid as the one used in master cylinder reservoir.
• Never use other fluid or thinner.
• Before installing piston and piston seal to cylinder,
apply fluid to them.
• After reassembling brake lines, bleed air from them.
1) Check that slide bushes and boots for wear, corrosion, dam-
age, movement or deterioration. If it is found faulty, correct or
replace.
Apply rubber grease to bush outer surface. And then make
sure that each bush slides easily through each caliper bolt
hole.
NOTE:
Where temperature gets as low as – 30 °C (– 22 °F) in cold
weather, use rubber grease whose viscosity varies very
little even at – 40 °C (– 40 °F).
2) Tighten bleeder plug to specified torque and install cap.
Tightening torque
Front caliper bleeder plug
(a) : 11 N·m (1.1 g-m, 8.0 lb-ft)
1. Apply rubber grease
3) Piston seal is used to seal piston and cylinder and to adjust
clearance between pad and disc. Replace with a new one at
every overhaul. Fit piston seal into groove in cylinder taking
care not to twist it.
4) Before inserting piston (2) into cylinder, install new boot (1)
onto piston (2) as shown.
"A" : 2-grooved side directed inside
"B" : 3-grooved side directed outside