5-16 BRAKES
4) If rear brake pressure is not within specification, adjust it by
changing stay position as follows.
• If rear brake pressure is higher than specification, move stay
"A" to direction "l" and if it is lower, to direction "r".
• Repeat steps 3) and 4) until rear brake pressure is within
specification.
• After adjustment, be sure to torque bolt to specification.
Tightening torque
LSPV adjust bolt
(a) : 25 N·m (2.5 kg-m, 18 Ib-ft)
1. LSPV lever
2. LSPV spring
3. LSPV stay
5) Disconnect brake pipe (2) (connecting between master cylin-
der secondary side and 4-way joint) from master cylinder (1).
Tighten plug (special tool) to master cylinder.
Depress brake pedal. If rear brake pressure is 95 – 100
2
kg/cm
when front brake pressure is 100 kg/cm
that front fail-safe system functions properly.
Front brake
10000 kPa
2
100 kg/cm
1422 psi
Special tool
(A) : 09956-02210
2
, it means
Rear brake
9500 – 10000 kPa
2
95 – 100 kg/cm
1350 – 1422 psi