Inspection And Adjustment - Suzuki Jimny Service Manual

5-46 BRAKES
4) Disconnect push rod clevis pin (4) from brake pedal arm (3).
5) Remove attaching nuts (6) and then booster as shown.
1. Steering column
2. Push rod clevis
5. Clip
INSTALLATION
NOTE:
• See NOTE at the beginning of this section.
• Check length of push rod clevis and adjust clearance
between booster piston rod and master cylinder pis-
ton. Refer to "Brake Booster Inspection and Adjust-
ment" in this section
• Apply silicone grease to master cylinder piston.
1) Install booster to dash panel as shown, Then connect
booster push rod clevis (2) to pedal arm (3) with clevis pin
(4) and clip (5).
2) Tighter booster attaching nuts to the specified torque.
Tightening torque
Booster nuts
(a) : 13 N·m (1.3 kg-m, 9.5 Ib-ft)
3) Connect brake vacuum hose to brake booster.
4) Install master cylinder, referring to "Master Cylinder" in this
section.
1. Steering column

Inspection and adjustment

INSTALLATION POSITION OF PUSH ROD
Install push rod clevis (1) so that measurement "a" is obtained
and torque nut (2) to specification.
Tightening torque
Booster clevis nut
(a) : 25 N·m (2.5 kg-m, 18.0 Ib-ft)
Distance "a" between center of booster clevis pin hole
and booster surface
Standard : 126.1 – 127.1 mm (4.96 - 5.00 in.)