On-Vehicle Service; Rear Shock Absorber - Suzuki Jimny Service Manual

Jimny suzuki

Hide thumbs Also See for Jimny:

Table of Contents

When discarding shock absorber, be sure to refer to instructions in "Rear Shock Absorber Check" in

this section for proper procedure as it is gas sealed type.

The shock absorber is non-adjustable, non-refillable, and cannot be disassembled. The only service the shock

absorber requires is replacement when it has lost its resistance, is damaged, or leaking fluid.

• Check wheel bearings for wear. When measuring thrust

play, apply a dial gauge to axle shaft center after removing

wheel center cap from wheel disc.

When measurement exceeds limit, replace bearing.

Rear wheel bearing thrust play limit

: 0.8 mm (0.03 in.)

• By rotating wheel actually, check wheel bearing for noise and

smooth rotation. If it is defective, replace bearing.

On-Vehicle Service

1) Hoist vehicle.

2) Support rear axle housing (1) by using floor jack (2) to pre-

vent it from lowering.

REAR SUSPENSION 3E-5

Table of Contents