Suzuki Jimny Service Manual page 368

Engine Diagnostic Flow Table
Refer to the following pages for the details of each step.
Step
1 Customer Complaint Analysis
1) Perform customer complaint analysis referring to the
followings.
Was customer complaint analysis performed?
2 Diagnostic Trouble Code (DTC) and Freeze Frame Data
Check, Record and Clearance
1) Check for DTC (including pending DTC) referring to the
followings.
Is there any DTC(s)?
3 Visual Inspection
1) Perform visual inspection referring to the followings.
Is there any faulty condition?
4 Visual Inspection
1) Perform visual inspection referring to the followings.
Is there any faulty condition?
5 Trouble Symptom Confirmation
1) Confirm trouble symptom referring to the followings.
Is trouble symptom identified?
6 Rechecking and Record of DTC / Freeze Frame Data
1) Recheck for DTC and freeze frame data referring to
"DTC Check" section.
Is there any DTC(s)?
7 Rechecking and Record of DTC / Freeze Frame Data
1) Recheck for DTC and freeze frame data referring to
"DTC Check" section.
Is there any DTC(s)?
8 Engine Basic Inspection and Engine Diagnosis Table
1) Check and repair according to "Engine Basic Inspec-
tion" and "Engine Diagnosis Table" section.
Are check and repair complete?
9 Trouble shooting for DTC
1) Check and repair according to applicable DTC diag.
flow table.
Are check and repair complete?
10 Check for Intermittent Problems
1) Check for intermittent problems referring to the follow-
ings.
Is there any faulty condition?
11 Final Confirmation Test
1) Clear DTC if any.
2) Perform final confirmation test referring to the follow-
ings.
Is there any problem symptom, DTC or abnormal condi-
tion?
Action
ENGINE GENERAL INFORMATION AND DIAGNOSIS 6-11
Yes
Go to Step 2.
Print DTC and freeze
frame data or write them
down and clear them by
referring to "DTC Clear-
ance" section.
Go to Step 3.
Repair or replace mal-
function part.
Go to Step 11.
Go to Step 6.
Go to Step 9.
Go to Step 11.
Repair or replace mal-
function part(s).
Go to Step 11.
Go to Step 6.
No
Perform cus-
tomer complaint
analysis.
Go to Step 4.
Go to Step 5.
Go to Step 8.
Go to Step 7.
Go to Step 8.
Go to Step 10.
Check and
repair malfunc-
tion part(s).
Go to Step 11.
Go to Step 11.
End.