On-Vehicle Service; Starting Motor - Suzuki Jimny Service Manual

Starting Motor

1. Starting motor
2. Clutch housing upper plate
DISMOUNTING
1) Disconnect negative (–) battery lead at battery.
2) Disconnect magnetic switch lead wire (6) and battery cable (7) from starting motor terminals.
3) Remove starting motor mount bolts (4) and nut (5).
4) Remove starting motor (1).
REMOUNTING
Reverse the dismounting procedure.
NO-LOAD PERFORMANCE TEST
Connect battery and ammeter to starter as shown.
Check that starter rotates smoothly and steadily with pinion mov-
ing out. Check that ammeter indicates specified current.
Specified current (No-load performance test)
: 90 A MAX. at 11 V

On-Vehicle Service

3. Transmission case
4. Starting motor mounting bolt
5. Starting motor mounting nut
6. Magnetic switch lead wire
CRANKING SYSTEM 6G-5
7. Battery cable
Tightening Torque