Manual Transmission Oil; Automatic Transmission Fluid - Suzuki Jimny Service Manual

0B-16 MAINTENANCE AND LUBRICATION

Manual Transmission Oil

INSPECTION
1) Inspect transmission case for evidence of oil leakage.
Repair leaky point if any.
2) Make sure that vehicle is placed level for oil level check.
3) Remove level plug (2) of transmission.
4) Check oil level.
Oil level can be checked roughly by means of level plug hole.
That is, if oil flows out of level plug hole or if oil level is found
up to hole when level plug is removed, oil is properly filled.
If oil is found insufficient, pour specified amount of specified
oil.
5) Tighten level plug to specified torque.
Refer to "Maintenance Service" in Section 7A for installation
and tightening torque.
CHANGE
Change transmission oil with new specified oil referring to "Main-
tenance Service" in Section 7A.

Automatic Transmission Fluid

INSPECTION
1) Inspect transmission case for evidence of fluid leakage.
Repair leaky point, if any.
2) Make sure that vehicle is placed level for fluid level check.
3) Check fluid level.
For fluid level checking procedure, refer to "Fluid Level
Check" in Section 7B and be sure to perform it under speci-
fied conditions. If fluid level is low, replenish specified fluid.
1. Dipstick
2. "FULL HOT" mark
3. "LOW HOT" mark
CHANGE
1) Inspect transmission case for evidence of fluid leakage.
Repair leaky point, if any.
2) Make sure that vehicle is placed level for fluid level check.
3) Change fluid. For its procedure, refer to "Changing Fluid" in
Section 7B.
CAUTION:
Use of specified fluid is absolutely necessary.
1. Drain plug