Suzuki Jimny Service Manual page 559

6A1-78 ENGINE MECHANICAL (M13 ENGINE)
• Install seal ring and exhaust pipe to exhaust manifold.
Tighten pipe fasteners to specified torque.
Tightening torque
Exhaust pipe bolts (a) : 50 N·m (5.0 kg-m, 36.5 lb-ft)
6) Reverse disconnected hoses, cables and electric wires for
connection.
7) Install air cleaner outlet hoses.
8) Install radiator with cooling fan and connect A/T fluid hoses
(vehicle with A/T), radiator inlet and outlet hoses referring to
"Water Pump Belt and Cooling Fan" and "Radiator" in Sec-
tion 6B.
9) Adjust generator belt tension referring to "Water Pump Belt
Tension" in Section 6B.
10) Adjust A/C compressor and/or P/S pump belt tension (if
equipped) referring to "Compressor Drive Belt" in Section 1B
or "Power Steering Belt" in Section 3B1.
11) Adjust accelerator cable play referring to "Accelerator Cable
Adjustment" in Section 6E.
12) Check to ensure that all removed parts are back in place.
Reinstall any necessary parts which have not been rein-
stalled.
13) Refill cooling system with coolant engine with engine oil and
A/T with specified A/T fluid (vehicle with A/T).
14) Connect negative cable at battery.
15) Verify that there is no fuel leakage, coolant leakage, oil leak-
age, A/T fluid leakage (vehicle with A/T) and exhaust gas
leakage at each connection.