Pistons, Piston Rings, Connecting Rods And Cylinders - Suzuki Jimny Service Manual

6A1-62 ENGINE MECHANICAL (M13 ENGINE)

Pistons, Piston Rings, Connecting Rods and Cylinders

1. Top ring
2. 2nd ring
3. Oil ring
4. Piston
5. Connecting rod
: Apply engine oil to sliding surface except inner surface of big end, and rod bolts.
Make sure rod bolt diameter when reuse it due to plastic deformation tightening.
Refer to "Inspection" of "Connecting Rod".
6. Connecting rod bearing cap
: Point arrow mark on cap to crankshaft pulley side.
7. Connecting rod bearing
REMOVAL
1) Relieve fuel pressure referring to "Fuel Pressure Relief Pro-
cedure" in Section 6.
2) Disconnect negative cable at battery.
3) Drain engine oil.
4) Drain coolant.
5) Remove cylinder head referring to "Valves and Cylinder
Head" in this section.
6) Mark cylinder number on all pistons, connecting rods and
connecting rod caps using silver pencil or quick drying paint.
7) Remove rod bearing caps.
8. Piston pin
9. Piston pin circlip
10. Bearing cap nut
1) Tighten all nuts to 15 N·m (1.5 kg-m)
2) Turn all nuts to 45°
3) Then, turn all nuts to 45° once again
Tightening torque
Apply engine oil to sliding surface of each
parts.
Do not reuse.