Suzuki Jimny Service Manual page 348

3) Disconnect ABS hydraulic unit / control module assembly
connector (1) by pulling up lock.
4) Remove ABS hydraulic unit / control module assembly with
its bracket.
2. Lock position
3. Unlock position
5) Remove three bolts (3) and take out ABS hydraulic unit /
control module assembly (1) from bracket (2).
CAUTION:
• Do not give an impact to hydraulic unit.
• Use care not to allow dust to enter hydraulic unit.
• Do not place hydraulic unit on its side or upside down.
Handling it in inappropriate way will affect its original
performance.
INSTALLATION
1) Install hydraulic unit by reversing removal procedure.
Tightening torque
Brake pipe flare nuts
(a) : 16 N·m (1.6 kg-m, 12.0 lb-ft)
ABS hydraulic unit / control module assembly bracket
bolts
(b) : 11 N·m (1.1 kg-m, 8.0 lb-ft)
ABS hydraulic unit / control module assembly bolts
(c) : 9 N·m (0.9 kg-m, 6.5 lb-ft)
2) Bleed air from brake system referring to "Air Bleeding of
Brake System" in Section 5.
3) Check each installed part for fluid leakage and perform
hydraulic unit operation check.
1. To left front
2. To right front
3. To rear
4. From proportioning valve
ANTILOCK BRAKE SYSTEM (ABS) 5E-31