3B1-20 POWER STEERING (P/S) SYSTEM (If equipped)
• Install pitman arm (1) to sector shaft (2) of P/S gear box (3)
with match marks "A" and "B" aligned as shown in figure and
torque to specification.
Tightening torque
Pitman arm mounting nut
(a) : 135 N·m (13.5 kg-m, 98.0 lb-ft)
• Install lower shaft by the following steps.
1) Align flat part of steering gear box worm shaft (1) with bolt
hole in lower joint as shown. Then insert lower joint (2) onto
worm shaft.
2) Be sure that front wheels and steering wheel are in straight-
forward state and insert upper joint onto steering shaft.
3) Torque lower shaft joint bolt to specification.
Tightening torque
Steering shaft lower joint bolt
(a) : 25 N·m (2.5 kg-m, 18.0 lb-ft)
• Fill engine coolant to radiator.
• Bleed air in P/S circuit referring to "Air Bleeding Procedure"
in this section.