Oil Pressure Check - Suzuki Jimny Service Manual

Oil Pressure Check

NOTE:
Prior to checking oil pressure, check the following items.
• Oil level in oil pan.
If oil level is low, add oil up to Full level mark (hole) (1) on oil
level gauge.
2. Low level mark (hole)
• Oil quality.
If oil is discolored, or deteriorated, change it.
For particular oil to be used, refer to the table in Section 0B.
• Oil leaks.
If leak is found, repair it.
1) Disconnect oil pressure switch coupler (1) and remove oil
pressure switch (2) from cylinder block.
2) Install special tools (Oil pressure gauge) to vacated threaded
hole.
Special tool
(A) : 09915-77310
(B) : 09915-78211
3) Start engine and warm it up to normal operating tempera-
ture.
NOTE:
Be sure to place transmission gear shift lever in "Neu-
tral" (shift selector lever to "P" range for A/T model), and
set parking brake and block drive wheels.
4) After warming up, raise engine speed to 4,000 rpm and mea-
sure oil pressure.
Oil pressure specification
280 – 430 kPa (2.8 – 4.3 kg/cm
rpm
5) Stop engine and remove oil pressure gauge and attachment.
ENGINE MECHANICAL (M13 ENGINE) 6A1-7
2
, 39.8 – 61.1 psi) at 4,000