Suzuki Jimny Service Manual page 324

1) MALFUNCTION ANALYSIS
a) Customer Complaint Analysis
Record details of the problem (failure, complaint) and how it occurred as described by the customer.
For this purpose, use of such a questionnaire form as shown below will facilitate collecting information to
the point required for proper analysis and diagnosis.
CUSTOMER QUESTIONNAIRE (EXAMPLE)
b) Problem Symptom Confirmation
Check if what the customer claimed in "Customer Questionnaire" is actually found in the vehicle and if the
symptom is found, determine whether it is identified as a failure. (This step should be shared with the cus-
tomer if possible.) When "ABS" warning lamp is not operating correctly, proceed to "Diagnostic Flow Table-
A, B or C" in this section.
c) Diagnostic Trouble Code (DTC) Check, Record and Clearance
Perform "Diagnostic Trouble Code Check" procedure in this section, record it and then clear it referring to
"Diagnostic Trouble Code Clearance" in this section.
If the malfunction DTC which was once displayed and then cleared cannot be detected (indicated) again
when the ignition switch is turned ON, attempt to diagnose the trouble based on the DTC recorded in this
step may mislead the diagnosis or make diagnosing difficult. Proceed to Step 2 to check ABS control mod-
ule for proper self-diagnosis function.
If the malfunction DTC which was once displayed and then cleared can be detected (indicated) again when
ignition switch is turned ON, proceed to Step 3.
ANTILOCK BRAKE SYSTEM (ABS) 5E-7