Suzuki Jimny Service Manual page 486

Jimny suzuki

Hide thumbs Also See for Jimny:

Table of Contents

10) Disengage clutch (1) (to lighten starting load on engine) for

M/T vehicle, and depress accelerator pedal (2) all the way to

make throttle fully open.

11) Crank engine with fully charged battery, and read the highest

pressure on compression gauge.

• For measuring compression pressure, crank engine at

least 250 rpm by using fully charged battery.

• If check results are below the limit valve, check instal-

lation condition for special tool.

Compression pressure specification

Max. difference between

any two cylinders

12) Carry out Steps 9) through 11) on each cylinder to obtain 4

13) After checking, install spark plugs and ignition coil assem-

blies (1) with high-tension cord (2).

14) Connect ignition coil couplers (3).

15) Connect fuel injector wires (4) at the coupler.

16) Check cylinder head upper cover gasket for deterioration and

then install it into groove of cylinder head upper cover (1)

17) Install cylinder head upper cover with gasket on to cylinder

18) Connect accelerator cable (2) to clamp (3) (For left hand

steering vehicle only).

ENGINE MECHANICAL (M13 ENGINE) 6A1-5

, 199.0 psi)

, 156.0 psi)

Chapters

Table of Contents