6A1-74 ENGINE MECHANICAL (M13 ENGINE)
a) For right hand steering vehicle:
With hose connected, detach A/C compressor from its
bracket.
NOTE:
Suspend removed A/C compressor at a place where no
damage will be caused during removal and installation of
engine assembly.
b) For left hand steering vehicle:
i) Recover refrigerant from refrigeration system using recov-
ery and recycling equipment.
ii) Disconnect magnet clutch lead wire.
iii) Remove suction pipe and disconnect discharge pipe from
A/C compressor.
iv) Remove A/C compressor from its bracket.
When servicing above steps, refer to "Compressor" in Section 1B.
14) Remove air cleaner outlet No.1 and No.2 hoses.
15) Disconnect the following electric lead wires:
• TP sensor (1)
• MAP sensor (2)
• CKP sensor (if equipped) (3)
• CMP sensor
• ECT sensor
• Heated oxygen sensor
• EGR valve (if equipped)
• IAC valve (4)
• EVAP canister purge valve (5)
• Injectors (6)
• Ignition coils
• Generator
• Starting motor
• Oil pressure switch
• Ground terminal from intake manifold and cylinder block
• Each wire harness clamps
16) Remove intake manifold bracket (7) with main harness from
intake manifold.
17) Remove starting motor referring to "Dismounting" in Section
6G.