INSPECTION
• Check oil seal (1) lip for fault or other damage.
Replace as necessary.
NOTE:
When installing new oil seal, tap it in until its surface is
flash with edge of timing chain cover (2).
To install oil seal, use special tool (Bearing installer).
Special tool
(A) : 09913-75520
INSTALLATION
Reverse removal procedure to install timing chain cover, noting
the following points.
1) Apply sealant "A" to mating surface of cylinder and cylinder
head and "B" to mating surface of timing chain cover as
shown in figure.
"A" : Sealant 99000-31140
"B" : Sealant 99000-31150
Sealant amount for timing chain cover
Width "a" : 3 mm, 0.12 in.
Height "b" : 2 mm, 0.08 in.
2) Apply engine oil to oil seal lip, then install timing chain cover
(1) and water outlet pipe (2).
Tighten bolts and nut to specified torque.
NOTE:
Before installing timing chain cover, check that pin is
securely fitted.
Tightening torque
Timing chain cover bolts and nut
(a) : 23 N·m (2.3 kg-m, 17.0 lb-ft)
ENGINE MECHANICAL (M13 ENGINE) 6A1-31