Dcscm Configuration Task List - Edge-Core ES4626 User Manual

is located at layer 3, it only takes control over the IP address transmitting packets.
The Service-Oriented Priority Strategy Multicast of Security Controllable technology
adopts the following mode: for multicast data in limit range, set the priority specified by
the user at the join-in end so that data can be sent in a higher priority on TRUNK port,
consequently guarantee the transmission is processed in user-specified priority in the
entire network.

20.5.2 DCSCM Configuration Task List

1) Source Control Configuration
2) Destination Control Configuration
3) Multicast Strategy Configuration
1． Source Control Configuration
Source Control Configuration has three parts, of which the first is to enable source
control. The command of source control is as follows:
Command:
Global Configuration Mode
[no] ip multicast source-control
(Required)
The next is to configure the rule of source control. It is configured in the same
manner as for ACL, and uses ACL number of 5000-5009, every rule number can be used
to configure 10 rules. It is noticeable that these rules are ordered, the front one is the one
which is configured the earliest. Once the configured rules are matched, the following
rules won't take effect, so rules of globally allow must be put at the end. The commands
are
Command
Global Configuration Mode
Explanation
Enable source control globally, the "no ip
multicast source-control"
disables source
noticeable that, after enabling source control
globally, all multicast packets are discarded
by default. All source control configuration can
not be processed until the it is enabled
globally, while source control can not be
disabled until all
disabled.
Explanation
705
command
control globally. It
configured rules
is
are