Edge-Core ES4626 User Manual page 67

SDRAM and the NVRAM (if exists) besides sent to all terminals. To check the log save in
SDRAM and the NVRAM, we can use the show logging buffered command. To clear the
log save in NVRAM and SDRAM log buffer zone, we can use the clear logging command
2.2.9.2 System Log Configuration
2.2.9.2.1 System Log Configuration Task Sequence
1. Display and clear log buffer zone
2. Configure the log host output channel
1. Display and clear log buffer zone
Command
Admin Mode
show logging
warnings} |range <begin-index> <end-index>]
clear logging { sdram | nvram }
2. Configure the log host output channel
Command
Global Mode
logging {<ipv4-addr> | <ipv6-addr>} [ facility
<local-number> ] [level <severity>]
no logging
<ipv6-addr>}[ facility <local-number>]
2.2.9.2.2 System Log Configuration Command
2.2.9.2.2.1 show logging buffered
Command: show logging buffered [level { critical | warnings} | range <begin-index>
<end-index>]
Function: This command displays the detailed information in the log buffer channel. This
command is not supported on low end switches
Parameter: <begin-index> is the index start value of the log message, the valid range is
1-65535,<end-index> is the index end value of the log message, the valid range is
1-65535.
Command Mode:Admin Mode
Default:No parameter specified indicates all the critical log information will be displayed.
Usage Guide:Warning and critical log information is saved in the buffer zone. When
displayed to the terminal, their display format should be: index ID
ID [mission name] log information.
buffered|level{critical
{<ipv4-addr>
Description
Show detailed log information in
|
the log buffer channel
Clear log buffer zone information
Description
Enable the output channel of the
log host. The "no" form of this
command will disable the output
|
at the output channel of the log
host.
67
time <level> module