Edge-Core ES4626 User Manual page 695

3、 Configure DVMRP Sub-parameters (optional)
Configure DVMRP interface parameters
1） Configure the delay of transmitting report message on DVMRP interface and the
message number each time it transmits.
2）Configure metric value of DVMRP interface
3）Configure if DVMRP is able to set up neighbors with DVMRP routers which can
not Prune/Graft
4、 Configure DVMRP tunnel
1. Globally enable DVMRP Protocol
The basic configuration to function DVMRP routing protocol on EDGECORE series
Layer 3 switch is very simple. Firstly it is required to turn on DVMRP switch globally.
Command
Global Mode
[no] ip dvmrp multicast-routing
2. Enable DVMRP Protocol on the interface
The basic configuration to function DVMRP routing protocol on EDGECORE series
Layer 3 switch is very simple. After globally enabling DVMRP Protocol, it is required to
turn on DVMRP switch under corresponding interface.
Command
Interface Configuration Mode
ip dvmrp
[no] ip dvmrp
3. Configure DVMRP Sub-parameters
（1）Configure DVMRP Interface Parameters
1）Configure the delay of transmitting report message on DVMRP interface and the
message number each time it transmits.
2）Configure metric value of DVMRP interface
3）Configure if DVMRP is able to set up neighbors with DVMRP routers which can
not Prune/Graft
Command
Interface Configuration Mode
Explanation
Globally enable DVMRP Protocol, the "no ip
dvmrp multicast-routing"
disables DVMRP Protocol globally. (Required)
Explanation
Enable DVMRP Protocol on the interface, the
"no ip dvmrp" command disables DVMRP
Protocol on the interface.
Explanation
695
command