Radius-Server Authentication Host - Edge-Core ES4626 User Manual

server will be searched by the configured order if primary is not configured, otherwise,
the specified RADIUS server will be used first.
Command mode: Global Mode
Default: No RADIUS accounting server is configured by default.
Usage Guide: This command is used to specify the IPv4/IPv6 address and port number
of the specified RADIUS server for switch accounting, multiple command instances can
be configured. The <port-number> parameter is used to specify accounting port number,
which must be the same as the specified accounting port in the RADIUS server; the
default port number is 1813. If this port number is set to 0, accounting port number will be
generated at random and can result in invalid configuration. This command can be used
repeatedly to configure multiple RADIUS servers communicating with the switch, the
switch will send accounting packets to all the configured accounting servers, and all the
accounting servers can be backup servers for each other. If primary is specified, then
the specified RADIUS server will be the primary server.
Example: Sets the RADIUS accounting server of IP address to 100.100.100.60 as the
primary server, with the accounting port number as 3000.
Switch(Config)#radius-server accounting host 100.100.100.60 port 3000 primary

23.3.19 radius-server authentication host

Command: radius-server authentication host {<ipv4-address >|<ipv6-address>}
[port <port-number>] [primary]
no radius-server authentication host { ipv4-address >|<ipv6-address>}
Function: Specifies the IP address and listening port number for the RADIUS server; the
"no radius-server authentication host <IPaddress>" command deletes the RADIUS
authentication server
Parameters: <ipv4-address >|<ipv6-address> stands for the server IPv4/IPv6 address;
<port-number> for listening port number, from 0 to 65535, where 0 stands for
non-authentication server usage; primary for primary server.
Command mode: Global Mode
Default: No RADIUS authentication server is configured by default.
Usage Guide: This command is used to specify the IPv4/IPv6 address and port number
of the specified RADIUS server for switch authentication, multiple command instances
can be configured. The port parameter is used to specify authentication port number,
which must be the same as the specified authentication port in the RADIUS server, the
default port number is 1812. If this port number is set to 0, the specified server is regard
as non-authenticating. This command can be used repeatedly to configure multiple
RADIUS servers communicating with the switch, the configured order is used as the
844