Edge-Core ES4626 User Manual page 487

（2）Configure OSPF route introduction parameters
1）Configure default parameters (default type, default tag value, default cost
2）Configure the routes of the other protocols to introduce to OSPF.
（3）Configure other OSPF protocol parameters
1）Configure OSPF routing protocol priority
2）Configure cost for OSPF STUB area and default route
3）Configure OSPF virtual link
4）Configure the priority of the interface when electing designated layer3 switch
(DR).
3. Disable OSPF protocol
1. Enable OSPF protocol
Basic configuration of OSPF routing protocol on ES4626/ES4650 switch is quite
simple, usually only enabling OSPF and configuration of the OSPF area for the interface
are required. The OSPF protocol parameters can use the default settings. If OSPF
protocol parameters need to be modified, please refer to "2. Configure OSPF protocol
parameters".
Command
Global mode
[no] router ospf [process <id>]
OSPF protocol configuration mode
router-id <router_id>
no router-id
[no] network {<network> <mask> |
<network>/<prefix>} area <area_id>
[no] passive-interface
ethernet IFNAME | Vlan <ID>}
Explanation
Enables OSPF protocol; the "no router
ospf" command disables OSPF protocol
(required)
Configures the ID number for the layer3
switch running OSPF; the "no router id"
command cancels the ID number. The IP
address of an interface is selected to be
the layer3 switch ID. (optional)
Configure certain segment to certain area,
the no [no] network {<network> <mask>
| <network>/<prefix>} area <area_id>
command
(required)
Sets an interface to receive only, the [no]
passive-interface {IFNAME | ethernet
{IFNAME |
IFNAME | Vlan <ID>} command cancels
this configuration.
487
cancels this configuration.