Edge-Core ES4626 User Manual page 175

Parameter: <vlan-id> is the VID for the VLAN to be added the current port, valid range
is 1 to 4094.
Command mode: Interface Mode
Default: All ports belong to VLAN1 by default.
Usage Guide: Only ports in Access mode can join specified VLANs, and an Access port
can only join one VLAN at a time.
Example: Add some Access port to VLAN100.
Switch(Config)#interface ethernet 1/8
Switch(Config-ethernet1/8)#switchport mode access
Switch(Config-ethernet1/8)#switchport access vlan 100
Switch(Config-ethernet1/8)#exit
5.1.3.6 switchport interface
Command: switchport interface <interface-list>
no switchport interface <interface-list>
Ethernet port to VLAN; the "no
Function:Specify switchport interface
<interface-list>" command deletes one or one set of ports from the specified VLAN.
<interface-list> is the port list to be added or deleted, ";" and "-" are
Parameter:
supported, for example: ethernet 1/1;2;5 or ethernet 1/1-6;8.
Command mode: VLAN Mode
Default: A newly created VLAN contains no port by default.
Usage Guide: Access ports are normal ports and can join a VLAN, but a port can only
join one VLAN for a time.
Example: Assign Ethernet port 1, 3, 4-7, 8 of VLAN100.
Switch(Config-Vlan100)#switchport interface ethernet 1/1;3;4-7;8
5.1.3.7 switchport mode
Command: switchport mode {trunk|access}
Function: Set the port in access mode or trunk mode.
Parameter: trunk means the port allows traffic of multiple VLAN; access indicates the
port belongs to one VLAN only.
Command mode: Interface Mode
Default: The port is in Access mode by default.
Usage Guide: Ports in trunk mode is called Trunk ports. Trunk ports can allow traffic of
multiple VLANs to pass through. VLAN in different switches can be interconnected with
the Trunk ports. Ports under access mode are called Access ports. An access port can be
assigned to one and only one VLAN at a time.
Example: Set port 1/5 to trunk mode and port 1/8 to access mode.
175