Edge-Core ES4626 User Manual page 81

Configure an IP address to receive Trap
Switch(config)#snmp-server host 1.1.1.5 v1 usertrap
Delete a Trap receiving IP address
Switch(config)#no snmp-server host 1.1.1.5 v1 usertrap
Configure a Trap receiving IPv6 address
Switch(config)#snmp-server host 2001:1:2:3::1 v1 usertrap
Delete a Trap receiving IPv6 address
Switch(config)#no snmp-server host 2001:1:2:3::1 v1 usertrap
2.4.3.8 debug snmp mib
Command: debug snmp mib
no debug snmp mib
Function:Enable the SNMP mib debugging; the " no debug snmp mib" command
disables the debugging
Command Mode: Admin Mode
Usage Guide: When user encounters problems in applying SNMP, the SNMP debugging
is available to locate the problem causes.
Example:
Switch#debug snmp mib
2.4.3.9 debug snmp keneral
Command: debug snmp keneral
no debug snmp keneral
Function:Enable the SNMP keneral debugging; the "no debug snmp keneral"
command disables the debugging function
Command Mode: Admin Mode
Usage Guide:When user encounters problems in applying SNMP, the SNMP debugging
is available to locate the problem causes.
Example:
Switch#debug snmp keneral
2.4.3.10 show snmp engineid
Command: show snmp engineid
Function:Display the engine ID commands
Command Mode: Admin Mode
Example:
Switch#show snmp engineid
SNMP engineID:3138633303f1276c Engine Boots is:1
81