Mld Typical Application; Mld Troubleshooting - Edge-Core ES4626 User Manual

Example:Configure the MLD version to 2.
Switch(Config)#ipv6 mld version 2

21.3.4 MLD Typical Application

As shown in the following figure, add the Ethernet interfaces of Switch A and Switch
B to corresponding vlan, and start PIM6 on each vlan interface.
SwitchA
SwitchB
Vlan 2
Vlan 1
Vlan 1
Fig 21-3 Network Topology Diagram
The configuration procedure for SwitchA and SwitchB is as below:
(1) Configure SwitchA:
Switch (Config) #ipv6 pim multicast-routing
Switch (Config) #ipv6 pim rp-address 3FFE::1
Switch (Config) #interface vlan 1
Switch (Config-If-Vlan1) #ipv6 address 3FFE::1/64
Switch (Config-If-Vlan1) #ipv6 pim sparse-mode
(2) Configure SwitchB:
Switch (Config) #ipv6 pim multicast-routing
Switch (Config) #ipv6 pim rp-address 3FFE::1
Switch (Config) #interface vlan1
Switch (Config-If-Vlan1) #ipv6 address 3FFE::2/64
Switch (Config-If-Vlan1) #ipv6 pim sparse-mode
Switch (Config-If-Vlan1) #exit
Switch (Config) #interface vlan2
Switch (Config-If-Vlan2) #ipv6 address 3FFA::1/64
Switch (Config-If-Vlan2) #ipv6 pim sparse-mode
Switch (Config-If-Vlan2) #ipv6 mld query-timeout 150

21.3.5 MLD Troubleshooting

777