T Roubleshooting H Elp - Edge-Core ES4626 User Manual

address as 20, of dynamic ARP address as 20, NEIGHBOR list entry as 10. In VLAN 1,
set the max number of dynamic MAC address as 30, of dynamic ARP address as 30,
NEIGHBOR list entry as 20.
SWITCH A configuration task sequence:
Switch(config)#
Switch (config)#int ethernet 3/1
Switch (Config-If-Ethernet3/1)#switchport mac-address dynamic maximum 20
Switch (Config-If-Ethernet3/1)#switchport arp dynamic maximum 20
Switch (Config-If-Ethernet3/1)#switchport nd dynamic maximum 10
Switch (Config-if-Vlan1)#ip mac-address dynamic maximum 30
Switch (Config-if-Vlan1)#ip arp dynamic maximum 30
Switch (Config-if-Vlan1)#ipv6 nd dynamic maximum 20
24.5 The Number Limitation Function Of Port, MAC in
VLAN and IP Troubleshooting Help
The number limitation function of port, MAC in VLAN and IP is disabled by default, if
users need to limit the number of user accessing the network, they can enable it. If the
number limitation function of MAC address can not be configured, please check whether
Spanning-tree, dot1x, TRUNK is running on the switch and whether the port is configured
as a MAC-binding port. The number limitation function of MAC address is mutually
exclusive to these configurations, so if the users need to enable the number limitation
function of MAC address on the port, they should check these functions mentioned above
on this port are disabled.
If all the configurations are normal, after enabling the number limitation function of
port, MAC in VLAN and IP, users can use debug commands to debug every limitation,
check the details of number limitations and judge whether the number limitation function
is correct. If there is any problem, please sent result to technical service center.
877