Ip Igmp Snooping Vlan Suppression-Query-Time - Edge-Core ES4626 User Manual

in accordance with IGMP configuration as possible if layer 3 IGMP is running.
Example: Switch(config)#ip igmp snooping vlan 2 query- robustness 3

18.3.11 ip igmp snooping vlan suppression-query-time

Command: ip igmp snooping vlan <vlan-id> suppression-query-time <value>
no ip igmp snooping vlan <vlan-id> suppression-query-time
Function: Configure the suppression query time. The "no ip igmp snooping vlan
<vlan-id> suppression-query-time" command restores to the default value
Parameter: vlan-id: vlan id , ranging between <1-4094>
value: query interval, ranging between<1-65535> seconds
Command Mode: Global mode
Default: 255s
Usage Guide: This command can only be configured on L2 general querier. The
Suppression-query-time refers to the period of suppression state in which the querier
enters when receives query from the layer 3 IGMP in the segments.
Example: Switch(config)#ip igmp snooping vlan 2 suppression-query-time 270
18.4 IGMP Snooping Example
Scenario 1. IGMP Snooping function
Multicast
Mrouter Port
IGMP Snooping
Switch
Group 1 Group 1 Group 1 Group 2
Fig 18-1 Enabling IGMP Snooping function
Example: As shown in the above figure, a VLAN 100 is configured in the switch and
640