Vlan Interface Configuration - Edge-Core ES4626 User Manual

port; master to force the 1000Mb port to be master mode; slave to force the 1000Mb
port to be slave mode.
Command mode: Interface Mode
Default: Auto-negotiation for speed and duplex mode is set by default.
Usage Guide: This command applies to 1000Base-TX ports only. speed-duplex
command is not available for 1000Base-X port. For combo port, this command applies to
the 1000Base-TX port only and has no effect on 1000Base-X port. To change the
negotiation mode of 1000Base-X port, use negotiation command instead.
When configuring port speed and duplex mode, the speed and duplex mode must be the
same as the setting of the remote end, i.e., if the remote device is set to auto-negotiation,
then auto-negotiation should be set at the local port. If the remote end is in forced mode,
the same should be set in the local end.
1000Gb ports are by default master when configuring nonegotiate mode. If one end is
set to master mode, the other end must be set to slave mode. force1g-half Is not
supported yet.
Example: Port 1 of Switch 1 is connected to port 1 of SwitchB, the following will set both
ports in forced 100Mbps at half-duplex mode.
SwitchA(Config)#interface e1/1
SwitchA(Config-Ethernet1/1)#speed-duplex force100-half
SwitchB(Config)#interface e1/1
SwitchB(Config-Ethernet1/1)#speed-duplex force100-half

3.2.2 VLAN Interface Configuration

3.2.2.1 VLAN Interface Configuration Task List
1. Enter VLAN Mode
2. Configure the IP address for VLAN interface and enable VLAN interface.
1. Enter VLAN Mode
Command
Global Mode
interface vlan <vlan-id>
no interface vlan <vlan-id>
2. Configure the IP address for VLAN interface and enables VLAN interface.
Command
VLAN Mode
Explanation
Enters Interface Mode; the "no
interface vlan <vlan-id>" command
deletes specified VLAN interface.
Explanation
142