Edge-Core ES4626 User Manual page 676

Default: Disabled
Parameter: None
Command Mode: Global Mode
Usage Guide: When selecting RP, Pim usually will select according to RP priority. When
this command is configured, pim will not select according to RP priority. Unless there are
older routers in the net, this command is not recommended.
Example: Switch (config)#ip pim ignore-rp-set-priority
20.3.3.9 ip pim jp-timer
Command: ip pim jp-timer <value>
no ip pim jp-timer
Function: Configure to add JP timer. the "no ip pim jp-timer" command restores the
default value.
Parameter: <value> ranges from 10 to 65535s
Default: 60s
Command Mode: Global Mode
Usage Guide: Configure the interval of JOIN-PRUNE packets sent by PIM periodically,
the default value is 60s. The default value is recommended if no special reasons.
Example: Configure the interval of timer
Switch (config)#ip pim jp-timer 59
20.3.3.10 ip pim multicast-routing
Command: ip pim multicast-routing
no ip pim multicast-routing
Function: Enable PIM-SM globally. The "no ip pim multicast-routing » command
disables PIM-SM globally.
Parameter: None
Default: Disabled PIM-SM
Command Mode: Global Mode
Usage Guide: Enable PIM-SM globally. The interface must enable PIM-SM to have
PIM-SM work
Example: Enable PIM-SM globally.
Switch (Config)#ip pim multicast-routing
20.3.3.11 ip pim neighbor-filter
Command: ip pim neighbor-filter{<list-number>}
no ip pim neighbor-filter{<list-number>}
Function: Configure the neighbor access-list. If filtered by the lists and connections with
676