Edge-Core ES4626 User Manual page 331

Parameters: address1...address8 are IP addresses, in decimal format.
Default: No default gateway is configured for DHCP clients by default.
Command Mode: DHCP Address Pool Mode
Usage Guide: The IP address of default gateway(s) should be in the same subnet as the
DHCP client IP, the switch supports up to 8 gateway addresses. The gateway address
assigned first has the highest priority, and therefore address1 has the highest priority, and
address2 has the second, and so on.
Example: Configuring the default gateway for DHCP clients to be 10.1.128.2 and
10.1.128.100.
Switch(dhcp-1-config)#default-router 10.1.128.2 10.1.128.100
11.2.2.5 dns-server
Command: dns-server <address1>[<address2>[...<address8>]]
no dns-server
Function: Configure DNS servers for DHCP clients; the "no dns-server" command
deletes the default gateway.
Parameters: address1...address8 are IP addresses, in decimal format.
Default: No DNS server is configured for DHCP clients by default.
Command Mode: DHCP Address Pool Mode
Usage Guide: Up to 8 DNS server addresses can be configured. The DNS server
address assigned first has the highest priority, Therefore address 1 has the highest
priority, and address 2 has the second, and so on.
Example: Set 10.1.128.3 as the DNS server address for DHCP clients.
Switch(dhcp-1-config)#dns-server 10.1.128.3
11.2.2.6 domain-name
Command: domain-name <domain>
no domain-name
Function: Configures the Domain name for DHCP clients; the "no domain-name"
command deletes the domain name.
Parameters: <domain> is the domain name, up to 255 characters are allowed.
Command Mode: DHCP Address Pool Mode
Usage Guide: Specifies a domain name for the client.
Example: Specifying "edgecore.com" as the DHCP clients' domain name.
Switch(dhcp-1-config)#domain-name edgecore.com
11.2.2.7 hardware-address
Command: hardware-address <hardware-address>
331
[{Ethernet |