Edge-Core ES4626 User Manual page 755

Default: 60s
Command Mode: Global Mode
Usage Guide: If this value is configured at DR,it's the value of register suppression timer;
if this value is configured at RP and ipv6 pim rp-register-kat is not used at RP, this
command modifies Keepalive-period value. The "no ipv6 pim register-suppression"
command restores the default value.
Example: Configure the value of register suppression timer to 30s
Switch(config)# ipv6 pim register-suppression 30
21.2.3.17 ipv6 pim rp-address
Command: Ipv6 pim rp-address <rp-address> [<group-range> ]
no ipv6 pim rp-address <rp-address> [all|<group-range>]
Function: This command is to configure static RP globally or in a multicast address
range. The "no ipv6 pim rp-address" command cancels static RP.
Parameter: <rp-address> is the RP address, the format is X:X::X:X ,ipv6 address
<group-range> is the expected RP, the format is X:X::X:X/M, ipv6 address and prefix
length all the ranges
Default: This switch is not a RP static router
Command Mode: Global Mode
Usage Guide: This command is to configure static RP globally or in a multicast address
range.
Example: Configure 2000:112::8 as RP address globally
Switch (Config)# ipv6 pim rp-address 2000:112::8 ff1e::/64
21.2.3.18 ipv6 pim rp-candidate
Command: Ipv6 pim rp-candiate <ifname> [<group range>] [<priority>]
no ipv6 pim rp-candiate <ifname>
Function: This command is the candidate RP global configure command, it is used to
configure PIM-SM candidate RP information in order to compete RP router with other
candidate RPs.The "no ipv6 pim rp-candiate" command cancels the candidate RP.
Parameter: <ifname> is the name of the interface; <group range> is the group range of
the candidate RP,the format is X:X::X:X/M, ipv6 address and prefix length ; <priority> is
the RP selection priority, ranges from 0 to 255, the default value is 192, the lower value
has more priority
Default: This switch is not a RP static router.
Command Mode: Global Mode
Usage Guide: This command is the candidate RP global configure command, it is used
to configure PIM-SM candidate RP information in order to compete RP router with other
755