Edge-Core ES4626 User Manual page 48

Usage Guide: Reset the switch to factory settings. That is to say, all configurations made
by the user to the switch will disappear. When the switch is restarted, the prompt will be
the same as when the switch was powered on for the first time.
Note: After the command, "write" command must be executed to save the operation. The
switch will reset to factory settings after restart.
Example:
Switch#set default
Are you sure? [Y/N] = y
Switch#write
Switch#reload
2.1.1.25 setup
Command: setup
Function: Enter the Setup Mode of the switch.
Command mode: Admin Mode
Usage Guide: ES4626/ES4650 switch provides a Setup Mode, in which the user can
configure IP addresses, etc.
2.1.1.26 terminal length
Command: terminal length <0-512>
terminal no length
Function: Set columns of characters displayed in each screen on terminal; the "terminal
no length" cancels the screen switching operation and display content once in all.
Parameter: Columns of characters displayed in each screen, ranging between 0-512 (0
refers to non-stop display)
Command mode: Admin mode
Default: Default columns is 25
Usage guide: Set columns of characters displayed in each screen on terminal, so that
the-More-message will be shown when displayed information exceeds the screen. Press
any key to show information in next screen. 25 columns by default
Example: Configure treads in each display to 20
Switch#terminal length 20
2.1.1.27 terminal monitor
Command: terminal monitor
terminal no monitor
Function: Copy debugging messages to current display terminal; the "terminal no
monitor" command restores to the default value
48