Edge-Core ES4626 User Manual page 62

Example:
Switch#show ssh-user
test
2.2.7.1.8 show startup-config
Command: show startup-config
Function: Display the switch parameter configurations written into the Flash memory at
the current operation; those are usually also the configuration files used for the next
power-up.
Default: If the configuration parameters read from the Flash are the same as the default
operating parameter, nothing will be displayed.
Command mode: Admin Mode
Usage Guide: The show running-config command differs from show startup-config in
that when the user finishes a set of configurations, show running-config displays the
added-on configurations whilst show startup-config won't display any configurations.
However, if write command is executed to save the active configuration to the Flash
memory, the displays of show running-config and show startup-config will be the
same.
2.2.7.1.9 show interface switchport
Command: show interface switchport [ethernet <interface-list>]
Function: Show the VLAN port mode, VLAN number and Trunk port messages of the
VLAN port mode on the switch.
Parameter: <interface-list> is the port number or port list, which could be any port
information existing in the switch
Command mode: Admin mode
Example: Show VLAN messages of port ethernet 1/1.
Switch#show interface switchport ethernet 1/1
Ethernet1/1
Type :Universal
Mac addr num :-1
Mode :Access
Port VID :1
Trunk allowed Vlan :ALL
Displayed Information
Ethernet1/1
Type
Mac addr num
Mode :Access
Description
Corresponding interface number of the Ethernet
Current interface type
Number of interfaces with MAC address learning
ability
Current interface VLAN mode
62