Configuration Examples - Edge-Core ES4626 User Manual

address and prefix length; <gateway-address> is the next-hop IP address show in
dotted decimal notation; <gateway-interface> is the next-hop interface, < distance > is
the route managing distance value ranging between 1～255.
Default: Default static route managing value is 1.
Command Mode: Global mode
Usage Guide: VPN route forwarding instances have to be successfully configured before
using this command.

17.3.5 Configuration Examples

The figure shown below is a simple network consisting of three layer3 switches, the
network mask for all switches and PC is 255.255.255.0. PC-A and PC-C are connected
via the static route set in SwitchA and SwitchC; PC3 and PC-B are connected via the
static route set in SwitchC to SwitchB; PC-B and PC-C is connected via the default route
set in SwitchB.
PC-A:10.1.1.2
vlan1:10.1.1.1
SwitchA
Configuration steps:
Configuration of layer3 SwitchA
Switch#config
Switch (config) #ip route 10.1.5.0 255.255.255.0 10.1.2.2
Configuration of layer3 SwitchC
Switch#config
Next hop use the partner IP address
Switch(config)#ip route 10.1.1.0 255.255.255.0 10.1.2.1
Next hop use the partner IP address
PC-C:10.1.5.2
SwitchC vlan3:10.1.5.1
vlan2:10.1.2.2
vlan2:10.1..2.1 vlan1:10.1.3.1
Fig 17-2 Static Route Configurations
434
PC-B:10.1.4.2
vlan1:10.1.3.2
vlan2:10.1.4.1
SwitchB