Edge-Core ES4626 User Manual page 40

no enable password
Function: Configure the password used for enter Admin Mode from the User Mode,
The "no enable password" command deletes this password
Parameter: password is the configured code. Encryption will be performed by entering 8.
Command mode: Global Mode
Default: This password is empty by system default
Usage Guide: Configure this password to prevent unauthorized entering Admin Mode. It
is recommended to set the password at the initial switch configuration. Also, it is
recommended to exit Admin Mode with "exit" command when the administrator needs to
leave the terminal for a long time.
Example: Set the Admin user password to "admin".
Switch(Config)#enable password 8 admin
2.1.1.8 exec-timeout
Command: exec-timeout <minutes > [<seconds>]
no exec-timeout
Function:Configure the timeout of exiting admin mode. The "no exec-timeout"
command restores the default value.
Parameters: < minute > is the time value shown in minute and ranges between
0~35791.<seconds> is the time value shown in seconds and ranges between
0~2147483
Command mode: Global mode
Default: Default timeout is 10 minutes.
Usage guide:To secure the switch, as well to prevent malicious actions from
unauthorized user, the time will be count from the last configuration the admin had made,
and the system will exit the admin mode at due time. It is required to enter admin code
and password to enter the admin mode again. The timeout timer will be disabled when
the timeout is set to 0.
Example: Set the admin mode timeout value to 6 minutes
Switch(Config)#exec-timeout 6
2.1.1.9 exit
Command: exit
Function: Quit current mode and return to it's previous mode.
Command mode: All Modes
Usage Guide: This command is to quit current mode and return to it's previous mode.
Example: Quit global mode to it's previous mode
Switch(Config)#exit
40