Port Channel Configuration Task List - Edge-Core ES4626 User Manual

For Port Channel to work properly, member ports of the Port Channel must have the
same properties as follows:
All ports are in full-duplex mode.
All Ports are of the same speed.
All ports are Access ports and belong to the same VLAN or are all Trunk ports.
If the ports are Trunk ports, then their "Allowed VLAN" and "Native VLAN"
property should also be the same.
If Port Channel is configured manually or dynamically on ES4626/ES4650 switch,
the system will automatically set the port with the smallest number to be Master Port of
the Port Channel. If the spanning tree function is enabled in the switch, the spanning tree
protocol will regard Port Channel as a logical port and send BPDU frames via the master
port.
Port aggregation is closely related with switch hardware. ES4626/ES4650 switch allow
physical port aggregation of any two switches, maximum 8 port groups and 8 ports in
each port group are supported.
Once ports are aggregated, they can be used as a normal port. ES4626/ES4650
switch have a built-in aggregation interface configuration mode, the user can perform
related configuration in this mode just like in the VLAN and physical port configuration
mode.

4.2 Port Channel Configuration Task List

1． Create a port group in Global Mode.
2． Add ports to the specified group from the Port Mode of respective ports.
3． Enter port-channel configuration mode.
1. Creating a port group
Command
Global Mode
port-group
[load-balance { src-mac | dst-mac |
dst-src-mac | src-ip| dst-ip|dst-src-ip}]
no port-group <port-group-number
[ load-balance]
2. Add physical ports to the port group
<port-group-number>
Explanation
Creates or deletes a port group and sets
the load balance method for that group.
>
157