Edge-Core ES4626 User Manual page 756

candidate RPs.Only this command is configured, this switch is the RP candidate router
Example: Configure vlan1 as the sending interface of candidate RP announce messages
Switch (Config)# ipv6 pim rp-candidate vlan1 100
21.2.3.19 ipv6 pim rp-register-kat
Command: ipv6 pim rp-register-kat <vaule>
no ipv6 pim rp-register-kat
Function: This command is to configure the KAT(KeepAlive Timer)value of the
RP(S,G)items, the unit is second. The "no ipv6 pim rp-register-kat" command restores
the default value
Parameter: <vaule> is the timer value, ranges from 1 to 65535s
Default: 185s
Command Mode: Global Mode
Usage Guide: Configure rp-register-kat interval to 30s
Example: Switch(config)# ipv6 pim rp-register-kat 30
21.2.3.20 ipv6 pim sparse-mode
Command: ipv6 pim sparse-mode [passive]
no ipv6 pim sparse-mode [passive]
Function: Enable PIM-SM on the interface. no ipv6 pim sparse-mode [passive]
disables PIM-SM.
Parameter: [passive] means to disable PIM-SM (that's PIM-SM doesn't receive any
packets) and only enable IGMP(receive and transmit IGMP packets).
Default: Disabled PIM-SM
Command Mode: Interface Configuration Mode
Usage Guide: Enable PIM-SM on the interface. The command can configure on IPv6
tunnel interface, but it is successful configuration to only configure tunnel carefully.
Example: Enable PIM-SM on the interface vlan1
Switch (Config)#interface vlan 1
Switch(Config-If-Vlan1)#ipv6 pim sparse-mode
21.2.3.21 ipv6 pim ssm
Command: ipv6 pim ssm {default|range <access-list-name >}
no ipv6 pim ssm
Function: Configure the range of pim ssm multicast address. The "no ipv6 pim ssm"
command deletes configured pim ssm multicast group.
Parameter: default : indicates the default range of pim ssm multicast group is ff3x::/32.
<access-list-number > is the name of applying access-list.
756