Edge-Core ES4626 User Manual page 562

Router configuration mode
neighbor { <ip-address> | <TAG> }
weight <weight>
no neighbor { <ip-address> | <TAG> }
5．Configure BGP Route Filtering policy based on neighbor
Command
Router configuration mode
neighbor {<ip-address>|<TAG>}
distribute-list
{<1-199>|<1300-2699>|<WORD>}
{in|out}
no neighbor {<ip-address>|<TAG>}
distribute-list
{<1-199>|<1300-2699>|<WORD>}
{in|out}
6．Configure Next-Hop
1） Set Next-Hop as the switch's address
Command
BGP configuration mode
neighbor { <ip-address> | <TAG> }
next-hop-self
no neighbor { <ip-address> | <TAG> }
next-hop-self
2）Cancel default Next-Hop through route map
Command
Route mapped configuration command
set ip next-hop <ip-address>
no set ip next-hop
7．Configure EGBP Multi-Hop
If the connections with outer neighbors are not direct, the following command can
configure neighbor Multi-Hop.
Command
Configure BGP neighbor weights; the no
neighbor { <ip-address> | <TAG> }
command recovers default weights.
Explanation
Filter neighbor
information. The
{<ip-address>|<TAG>}
{<1-199>|<1300-2699>|<WORD>}
{in|out} command cancels routing filter.
Explanation
While sending
Next-Hop as the switch's address; the no
neighbor { <ip-address> | <TAG> }
command
next-hop-self
setting.
Explanation
Set the Next-Hop attribute of outbound
route. The no set ip next-hop command
cancels this setting.
Explanation
562
routing updating
no neighbor
distribute-list
route Next-Hop set
cancels the