Edge-Core ES4626 User Manual page 593

17.8.3.47 neighbor description
Command: neighbor {<ip-address>|<TAG>} description <.LINE>
no neighbor {<ip-address>|<TAG>} description
Function: Configure the description string of the peer or peer group. The "no neighbor
{<ip-address>|<TAG>} description" command deletes the configurations of this string
<ip-address>: Neighbor IP address
Parameter:
<TAG>: Name of peer group
<.LINE>: Description string consists of displayable characters less than 80
Usage Guide: Configure the introduction of the peer or peer group
Command Mode: BGP mode and address-family mode
Default: Description string is empty
Example:
Switch(config-router)#neighbor 10.1.1.64 description s64down
Switch(config-router)#
17.8.3.48 neighbor distribute-list
Command:
{<1-199>|<1300-2699>|<WORD>} {in|out}
no neighbor {<ip-address>|<TAG>} distribute-list {<1-199>|<1300-2699>|<WORD>}
{in|out}
Function: Configure the policy applied in partner route update transmission. The "no
neighbor {<ip-address>|<TAG>} distribute-list {<1-199>|<1300-2699>|<WORD>}
{in|out}" command cancels the policy configuration
Parameter: <ip-address>: Neighbor IP address
<TAG>: Name of peer group
<1-199>|<1300-2699>|<WORD>: Number or name of the access-list
Default: Policy not applied
Command Mode: BGP route mode and address-family mode
Usage Guide: Configure the policies with access-list command and apply this command
on route sending and receiving. It will filter the update route from partner when use in
mode, and will filter the route from local side to partner with out mode.
Example:
Configure the access-list
Switch(config)#access-list 101 deny ip 100.1.0.0 0.0.1.255 any
Switch(config)#access-list 101 permit ip any any
Switch(config)#router bgp 100
Switch(config-router)# neighbor 10.1.1.66 distribute-list 101 out
neighbor {<ip-address>|<TAG>}
593
distribute-list