Edge-Core ES4626 User Manual page 656

2、 Configure PIM-DM auxiliary parameters (Optional)
3、 Configure PIM-DM interface parameters
4、 Configure PIM-DM hello message interval
1. Setup PIM-DM Protocol
The basic configuration to function PIM-DM routing protocol on EDGECORE series
Layer 3 switch is very simple. It is only required to turn on PIM Multicast switch in Global
Mode and turn on PIM-DM switch under corresponding interface.
Command
Global Mode
ip pim multicast-routing
And then turn on PIM-SM switch on the interface
Command
Interface Configuration Mode
ip pim dense-mode
2. Configure PIM-DM Sub-parameters
（1）Configure PIM-DM Interface Parameters
1）Configure PIM-DM hello message interval
Command
Interface configuration mode
ip pim hello-interval < interval>
no ip pim hello-interval
Command
Interface configuration mode
ip pim state-refresh
origination-interval
no ip pim state-refresh
origination-interval
3. Disable PIM-DM Protocol
Command
Interface configuration mode
Explanation
Make PIM-DM Protocol on each interface to
Enable status (but the commands below are
required to really enable PIM-DM protocol on
the interface )
Explanation
Setup PIM-DM Protocol of the interface
(Required)
Explanation
Configure interface PIM-DM hello message
interval; the "no ip pim hello-interval"
command restores the default value.
Explanation
Configure interface PIM-DM hello message
interval; the "no ip pim state-refresh
origination-interval" command restores the
default value.
Explanation
656