Edge-Core ES4626 User Manual page 543

L3 gigabit ethernet switch
Hide thumbs Also See for ES4626:
Table of Contents

Advertisement

ranged between 1~65535.
Default: The default delay time of send LSA on the interface is 1 second by default.
Command Mode: Interface Mode
Usage Guide:
The LSA ages by time in the layer 3 switches but not in the transmission process. So by
increasing the transmit-delay before sending LSA so that it will be sent out. The
command can configure on IPv6 tunnel interface, but it is successful configuration to only
configure tunnel carefully.
Example: Set the interface vlan 1 LSA sending delay to 3 seconds.
Switch#config terminal
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ipv6 ospf transmit-delay 3
17.7.3.14 ipv6 router ospf
Command: [no] ipv6 router ospf {area <area-id> [instance-id <instance-id>|tag
<tag>
[instance-id
<instance-id>]}
Function: Enable ospf route on the interface; the "[no] ipv6 router ospf {area <area-id>
[instance-id <instance-id>|tag <tag> [instance-id <instance-id>]]| tag <tag> area
<area-id> [instance-id <instance-id>]}" command cancels this configuration
Parameter: <area-id> is an area ID which could be shown in digits ranging between 0~
4294967295, or an IPv4 address
<instance-id> is the interface instance ID ranging between 0~255 and defaulted at 0.
<tag> ospfv3 process identifier
Default: Not configured
Command Mode: Interface Mode
Usage Guide: To enable this command on the interface, the area id must be configured.
The instance ID and instance tag are optional. The ospfv3 process allows one routing
instance for each instance ID. The route can be enabled on a interface with a instance ID.
If the instance IDs are different, several OSPF process can be run on one interface.
However different OSPF process should not use the same instance ID The command
can configure on IPv6 tunnel interface, but it is successful configuration to only configure
tunnel carefully.
Example:
Switch#config terminal
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ipv6 router ospf area 1 tag IPI instance-id 1
17.7.3.15 max-concurrent-dd
<instance-id>]]|
tag
543
<tag>
area
<area-id>
[instance-id

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Es4650Es4626 l3Es4650 l3

Table of Contents