Cluster Member; Cluster Auto-Add Enable - Edge-Core ES4626 User Manual

Default: There is no cluster by default.
Instructions: This command sets the switch as a commander switch and creates a
cluster. Before executing this command, users must configure a private IP address pool.
If users executes this command again, the cluster's name will be changed and this
information is distributed to the member switches. If users execute this command in a
member switch, an error will be displayed. If users execute this command again with a
new vlan id, the new vlan id is invalid.
Notice: On layer3 interface configured as cluster commander , avoid configuring
RIP,OSPF routing protocol, otherwise, those routing protocols will not work.
Example: Set the switch as a commander switch. The cluster's name is admin and the
vlan-id is vlan
Switch(config)#cluster commander admin vlan 2

27.3.5 cluster member

Command:cluster member
[<mem-id>]} [password <pass>]
no cluster member <mem-id >
Function: Add a candidate switch to the cluster in the commander switch; the "no
cluster member <mem-id >" command deletes a member switch from the cluster.
Parameter: <mem-id> is the member ID, valid range is 1 to 23; <cand-sn> is the
sequence number of the switch in the candidate switch list, valid range is 0 to 127. Users
can use ";" or "-" to specify multiple numbers or successive numbers; <mac-add> is the
MAC address of the member switch in the format of XX-XX-XX-XX-XX-XX; <pass> is the
privileged password of the member switch.
Command mode: Global Mode
Instructions: When this command is executed in the commander switch, the switch with
<mac-add> or <cand-sn> will be added to the cluster which the commander switch
belongs to. If this command is executed in a non-commander switch, an error will be
displayed.
Example: In the commander switch, add the candidate switch which has the sequence
number as 17 and password as mypassword to the cluster.
Switch(config)#cluster member candidate-sn 17 password mypassword

27.3.6 cluster auto-add enable

Command: cluster auto-add enable
no cluster auto-add enable
{candidate-sn <cand-sn> | mac-address <mac-add>
909