Dot1X Eapor Enable; Dot1X Enable - Edge-Core ES4626 User Manual

name and port number.
Command mode: Global Mode
Default: N/A.
Usage Guide: The dot1x address filter function is implemented according to the MAC
address filter table, dot1x address filter table is manually added or deleted by the user.
When a port is specified in adding a dot1x address filter table entry, that entry applies to
the port only; when no port is specified, the entry applies to all ports in the switch. When
dot1x address filter function is enabled, the switch will filter the authentication user by the
MAC address. Only the authentication request initialed by the users in the dot1x address
filter table will be accepted, the rest will be rejected.
Example: Adding MAC address 00-01-34-34-2e-0a to the filter table of Ethernet 1/5.
Switch(Config)#dot1x accept-mac 00-01-34-34-2e-0a interface ethernet 1/5

23.3.4 dot1x eapor enable

Command: dot1x eapor enable
no dot1x eapor enable
Function: Enables the EAP relay authentication function in the switch; the "no dot1x
eapor enable" command sets EAP local end authentication.
Command mode: Global Mode
Default: EAP relay authentication is used by default.
Usage Guide: The switch and RADIUS may be connected via Ethernet or PPP. If an
Ethernet connection exists between the switch and RADIUS server, the switch needs to
authenticate the user by EAP relay (EAPoR authentication); if the switch connects to the
RADIUS server by PPP, the switch will use EAP local end authentication (CHAP
authentication). The switch should use different authentication methods according to the
connection between the switch and the authentication server.
Example: Setting EAP local end authentication for the switch.
Switch(Config)#no dot1x eapor enable

23.3.5 dot1x enable

Command: dot1x enable
no dot1x enable
Function: Enables the 802.1x function in the switch and ports: the "no dot1x enable"
command disables the 802.1x function.
Command mode: Global Mode and Interface Mode.
Default: 802.1x function is not enabled in global mode by default; if 802.1x is enabled
837