Commands For Dvmrp - Edge-Core ES4626 User Manual

ip dvmrp output-report-delay
<delay_val> [<burst_size>]
no ip dvmrp output-report-delay
ip dvmrp metric <metric_val>
no ip dvmrp metric
ip dvmrp reject-non-pruners
no ip dvmrp reject-non-pruners
4. Configure DVMRP Tunnel
Command
Interface Configuration Mode
ip dvmrp tunnel <index>
<dst-ip>
no ip dvmrp tunnel {<index>
|<src-ip> <dst-ip>}

20.4.3 Commands for DVMRP

20.4.3.1 ip dvmrp
Command: ip dvmrp
no ip dvmrp
Function:Configure to enable DVMRP protocol on interface; the "no ip dvmrp"
command disenables DVMRP protocol.
Parameter: None
Default: Disable DVMRP Protocol
Command Mode: Interface Configuration Mode
Usage Guide:The interface processes DVMRP protocol messages, only executing
DVMRP protocol on interface.
Example: Enable DVMRP Protocol on interface vlan1.
Switch (Config)#interface vlan 1
Switch(Config-If-vlan1)#ip dvmrp
Configure the delay of transmitting DVMRP
report message on interface and the message
number each time it transmits, the "no ip
dvmrp
restores default value.
Configure interface DVMRP report message
metric value; the "no ip dvmrp metric"
command restores default value.
Configure the interface rejects to set up
neighbor
pruning/grafting DVMRP router. The "no ip
dvmrp
restores to being able to set up neighbor ship.
Explanation
<src-ip> This command configures a DVMRP tunnel;
the "no ip dvmrp tunnel {<index> |<src-ip>
<dst-ip>}" command deletes a DVMRP
tunnel.
696
output-report-delay"
relationship
reject-non-pruners"
command
with non
command