Edge-Core ES4626 User Manual page 905

27.2 Cluster
Sequence
1. Enable or disable cluster function
2. Create cluster
1) Create or delete cluster
2) Configure private IP address pool for member switches of the cluster
3) Add or remove a member switch
3. Configure attributes of the cluster in the commander switch
1) Enable or disable joining the cluster automatically
2) Set holdtime of heartbeat of the cluster
3) Set interval of sending heartbeat packets among the switches of the cluster
4) Clear the list of candidate switches discovered by the commander switch
4. Configure attributes of the cluster in the candidate switch
1) Set interval of sending cluster register packet
5. Remote cluster network management
1) Remote configuration management
2) Reboot member switch
3) Remotely upgrade member switch
1. Enable or disable cluster
Command
Global Mode
cluster run
no cluster run
2．Create a cluster
Network Management
905
Configuration
Explanation
Enable or disable cluster function
in the switch