Edge-Core ES4626 User Manual page 445

Command: [no] debug rip [events| nsm| packet[recv|send][detail]| all]
Function: Open various RIP adjustment switches and show various adjustment
debugging messages. The "[no] debug rip [events| nsm| packet[recv|send][detail]|
all]" command close corresponding debugging switch.
Parameter : events shows the debugging messages of RIP events
nsm shows the communication messages between RIP and NSM.
packet shows the debugging messages of RIP data packets.
recv shows the messages of the received data packets
send shows the messages of the sent data packets
detail shows the messages of received or sent data packets.
Default: Debug switch closed.
Command Mode: Admin Mode
Example: Switch# debug rip packet
Switch#1970/01/01 01:01:43 IMI: SEND[Vlan1]: Send to 224.0.0.9:520
1970/01/01 01:01:43 IMI: SEND[Vlan1]: Send to 224.0.0.9:520
1970/01/01 01:01:47 IMI: RECV[Vlan1]: Receive from 20.1.1.2:520
17.4.3.5 default-information originate
Command: default-information originate
no default-information originate
Function: Allow the network 0.0.0.0 to be redistributed into the RIP. The "no
default-information originate" disable this function.
Parameter: None
Default: Disabled
Command Mode: router mode
Example: Switch# config terminal
Switch(config)# router rip
Switch(config-router)# default-information originate
17.4.3.6 default-metric
Command: default-metric <value>
no default-metric
Function: Set the default metric value of the introduced route. The "no default-metric"
command restores the default value to 1.
Parameter: <value> is the metric value to be set, ranging between 1~16.
Default: Default route metric value is 1
Command Mode: Router mode and address-family mode
Usage Guide: default-metric command is used for setting the default route metric value
445