Edge-Core ES4626 User Manual page 469

Delete the specified route in RIPng route table
（4）
1. Enable RIPng protocol
Applying RIPng route protocol with basic configuration in ES4626/ES4650 switch is
simple. Normally you only have to open the RIPng switch and configure the segments
running RIPng, namely send and receive the RIPng data packet by default RIPng
configuration.
Command
Global mode
[no] router IPv6 rip
Interface configuration mode
[no] IPv6 router rip
2. Configure RIPng protocol parameters
（1）Configure RIPng sending mechanism
1）configure the RIPng data packets point-transmitting
Command
Router configuration mode
[no] neighbor
<ifname>
[no] passive-interface <ifname>
（2）Configure RIP routing parameters
1）configure route introduction (default route metric, configure routes of the other
protocols to be introduced in RIP)
Command
Router configuration mode
Explanation
Enables the RIPng protocol; the [no] router
IPv6 rip command shuts the RIPng protocol.
configure the interface to run RIPng protocol;
the [no] IPv6 router rip command set the
interface not run RIPng protocol
Explanation
Specify the IPv6 Link-local address and
interface of the neighboring route needs
<IPv6-address>
point-transmitting;
<IPv6-address> <ifname> command cancels
the appointed router.
Block the RIPng multicast on specified port
and
transmittable
configured
passive-interface
cancels the function
Explanation
469
the
the RIPng data
among Layer
with neighbor.
<ifname>
[no] neighbor
packet is only
3 switch
the [no]
command