Default Setting
Enabled
Command Mode
Global Configuration
Example
The following example enables IGMP snooping.
Console(config)#ip igmp snooping
Console(config)#
ip igmp snooping vlan static
This command adds a port to a multicast group. Use the no form to remove the port.
Syntax
[no] ip igmp snooping vlan vlan-id static ip-address interface
• vlan-id - VLAN ID (Range: 1-4094)
• ip-address - IP address for multicast group
• interface
• ethernet unit/port
- unit - Stack unit. (Range: 1)
- port - Port number. (Range: 1-10)
• port-channel channel-id (Range: 1-5)
Default Setting
None
Command Mode
Global Configuration
Example
The following shows how to statically configure a multicast group on a port:
Console(config)#ip igmp snooping vlan 1 static 224.0.0.12 ethernet 1/5
Console(config)#
ip igmp snooping version
This command configures the IGMP snooping version. Use the no form to restore
the default.
Syntax
ip igmp snooping version {1 | 2 | 3}
no ip igmp snooping version
• 1 - IGMP Version 1
Multicast Filtering Commands
4
4-275